More Flow. More Power. More Confidence

Hot and Cold Side Intercooler Charge Pipe Kit

Replace the factory plastic charge pipes with these premium 304 stainless steel charge pipes for enhanced performance and increased durability. The 2-inch hot side/2.2-inch cold side factory intercooler piping adds restriction to the intake system due to insufficient sizing and tight bends. The PPE charge pipe kit features 2.5-inch hot side pipe and 2.75-inch cold side pipe, increasing the cross-sectional flow area by 50% on both sides, eliminating factory restrictions and optimizing flow characteristics. The 304 stainless steel construction ensures these pipes deliver the performance you need even in the harshest environment.

Nodular Iron Rear Differential Cover

The PPE heavy-duty nodular iron differential cover is designed as a bolt-on upgrade for your thin, stamped steel factory diff cover. This cover offers maximum durability thanks to its thick, cast, high-strength nodular iron construction. Our cover has been carefully engineered to optimize your vehicle’s approach and departure angles, ensuring that it can navigate any terrain with ease. It is also built to handle the high torsion of challenging off-road environments, with transverse gussets that add strength and rigidity to the housing. When installed, the hardware is recessed within the flange and protected from potential damage.

Heavy-Duty Cast Aluminum Transmission Pan

Excessive heat kills transmission life. As temperature rises, transmission fluid viscosity decreases, weakening the lubricating film that protects gears and bearings. This could cause premature wear and potential failure. Cast from high-grade A356.0-T6 aluminum alloy, the PPE transmission pan offers 4 quarts of additional fluid capacity, ensuring long-lasting heat management and performance. The deep external cooling fins maximize the heat-wicking surface area, effectively dissipating heat to keep your transmission cool under pressure. These fins also add strength to the bottom of the pan and enhance impact resistance. The built-in baffles at the bottom of the pan increase contact between the fluid and the cast-aluminum surfaces, enhancing heat transfer. These baffles also reduce fluid sloshing, ensuring consistent fluid pickup and stable transmission performance. Together with the longitudinal external fins, they form a stiff, cross-bracing structure, distributing loads better and increasing impact resistance. The drain plug is equipped with a powerful, high-temperature-rated neodymium magnet that captures ferrous metal particles, providing additional protection for your transmission.

MicroPure® Engine Oil Filter - Replaces Motorcraft FL-910S

The oil filter is your engine’s first line of defense against contaminants that degrade oil performance and reduce oil lifespan. Poor filter performance and the presence of oil contaminants can lead to premature wear and potential failure of engine internals. The OEM filter falls short, only offering 136 square inches of 25-micron filtration capability and using a weak leaf spring, reducing seal quality and allowing dirty oil to blow past the filter media. PPE’s upgraded filter provides 177 square inches of filtration area, a 30% increase over the OEM filter. The specially engineered ultra-fine synthetic blend MicroPure® media achieves a 10-micron nominal rating. An integrated high-temperature rated neodymium magnet also allows the PPE filter to capture ferrous particles, preventing them from clogging the media, extending filter and oil life. The use of a heavy-duty coil spring ensures a secure seal between the media end cap and the base plate, eliminating dirty oil blow-by and maximizing filtration performance.